The 6 pictures below are of an antique coal basket using Bronze, Bronze Reflective and Starfire
The 6 pictures above are of an antique coal basket using Bronze,Bronze Reflective and Starfire
Bronze base, 3/16 Amber, Bronze Reflective and Yellow Topper.
These next three are also one of our newest products found in the Surrounds section
The several pictures below are of a modern coal basket of stainless steel with legs or it can be suspended with chains. This will also be one of our new product lines available in several sizes and finishes.
The 2 pictures below have Bronze, Bronze Reflective, Black, Black Reflective and Pale Cobalt Blue Topper.
The 3 pictures below have Bronze, Bronze Reflective, Gray and Gray Reflective with the outside of the fireplace painted medium brown with fireplace paint.
The fireplace below has Bronze and Bronze Reflective installed.
Now for the after pictures! This was a custom propane burner which was under all of the glass!
The fire pit below is in Malibu California which no one could figure out how to do what we did. The customer didn't want to see the fire pit hood anymore. So we just raised it. And everyone said it couldn't be done! This is what we like to do, take imagination and make it a reality. The base was provided by the customer we just supplied the "raise the hood" and the ring and Bronze Base Glass
and Bronze Reflective Base Glass
The vent went up 20 feet. E mail us and we will tell you how this was done.
The pictures below will show you how to install a propane burner
and valve in your fire pit without drilling a hole in the side of your fire pit with our FPPK (fire pit propane kit). This was install in Calabasas
California with Bronze Base Glass
and Bronze Reflective Base Glass
on top. The fire pit has 10" solid sides which made this a good candidate for the FPPK
to be installed on the inside wall. This is a propane fire pit and we do calibrate every valve to every ring we install to eliminate back flow and any problems or issues that may happen. We also install the proper air mixer to insure a clean burn as we eliminate the soot know to be produced by propane. If you have a propane fire pit you know what I am talking about. We can build whatever you may need foa control box cover, see our Metal Page!
The fireplace below is a before and after and a "how to" make it low and lean. A more contemporary look. This is a self install by Rich Kamins and one very nice job!. He used a Bronze Base Glass and Bronze Reflective Base Glass. Topper with a bit of Starfire Base Glass. Ice Ice Ice Topper and about 2 pounds of Copper Ruby Red Topper for a splash of color.
Typical nasty fireplace before Moderustic!
A few bricks and some drywall
The pictures below are of a self install with: 1/4" Bronze Base Glass
and 1/2" Bronze Base Glass
, 1/4" Starfire Base Glass
and 1/2" Starfire Base Glass, Red Topper, Red Topping
and about 1 lb of Scarlet Red Topper
And here you have one nice finished fireplace.
CLICK HERE TO PURCHASE IN THE E STORE!
The fireplace below is a self install with a 2" base of crushed lava
18 18 double burner
The fireplace below has a base of Gray and Bronze topped with Bronze and Gray Reflective.
CLICK HERE TO PURCHASE IN THE E STORE!
The fireplace below has a base of Bronze with Bronze Reflective and Starfire on top.
This is the back side of the peninsula fireplace.
CLICK HERE TO PURCHASE IN THE E STORE!
The fireplace below is from Cory here locally in
Rancho Cucamonga California. This transformation was a complete surface make over along with out Sterling Silver interior. The glass that was used was Bronze Base Glass and Bronze Reflective Base Glass. This is truly a DIY project and we like to help you create your ideas to reality.
Here we begin with the old interior brick panels removed.
Below you can see the new stone being applied.
Now you can see the reflection on the walls in the Sterling Silver panels
. No, these are not just mirrors in the fireplace. If you do try this, let us know how it worked out for you. Be sure to send us pictures of your project and we will be sure to post it on our "How Not To Do It Page
"! No, Really!
Again we are proud to constantly give you new and exciting products for your fireplace and fire pit projects.
Below is a collection we took pictures for our customer to decide on which base to use under the Amber Diamonds.
Amber Diamonds alone
Amber Diamonds on Black Base Glass
Amber Diamonds on Starfire Base Glass
Amber Diamonds on New Yellow Base Glass
Amber Diamonds on Bronze Base Glass
The same product can be displayed thousands of ways. What do you want to see? Our Diamonds
are made with a convex base so when you look at the Diamonds in the fire they seem to be melting on the inside, like looking into a spoon. We cause it to reflect backwards. Visit out "Diamonds Page" to see many more colors!
The fire pit below is going to be installed in Sacramento on 11 14 09 for the Yard Crashers/ DIY/ HGTV show. After it is and has been installed we will post pictures on the Yard Crashers page. In the mean time here is the how to and why. We can build any size, shape, design feature you desire. We build to your imagination.
Below is the catch basin to hold the water for the feature
Above you see the auto fill?
Below the water pump is now install below.
Below the top pan is in place for testing with the fire and water bowls in place
Below the stainless steel ring is installed.
Below the glass (Bronze Base Glass) has been installed and the lights turned on.
Below you can see the pump has been turned on.
and now the fire.
We placed a card board template to replicate the table top to conceal the lights as well.
Now we add color to the water!
Here is the feature exposed with the blue water. You can change the water to any color you like.
This feature is only 6 1/2" tall. You can mount this under the table top and keep it only an inch or so above the surface of the table top.
So let's change it to red water and add Starfire Base Glass.
Remember, we build to your imagination!
The finished pictures will be posted on the Yard Crashers page when this project is installed after 11 14 09!
"CLICK HERE to see the "Yard Crashers" Sacramento show!" See this feature finished here!
The fireplaces below are located in Palm Desert California. These were both filler with crushed lava (3" to 4" each) and then topped with a Bronze base glass. We then added 6" gray Fire Balls. We will explain as we proceed:
This was the outdoor fireplace. 38" "H" burner was installed.
We then poured in about 4" of crushed lava filler.
Then we poured in about 1 1/2" of Bronze base glass.
Then we stacked in the 6" gray Fire Balls. We couldn't get any burning pictures because it was to bright outdoors.
The fireplace below was indoors in the family room. We started with about 3" to 4" of filler (crushed lava). We used a 38" "H" burner again in this fireplace as well.
Then we tested the flame pattern to insure the flames were not hitting the walls.
Then we added the 6" gray Fire Balls to the top of the Bronze base glass.
One very nice family room!
The fireplace below was installed by Scott Hansford of Palm Springs California.
We made an aluminum border to separate the glass from the outer stone layer. This helped in design and saved on glass as well. We will explain as we move on:
Do you see how high the gas connection is? We sent a 90 degree elbow to point the gas line down and then added enough filler to the bottom of the gas line to conceal it under the glass.
The metal border is installed holding the outer layer of rock in place.
They didn't like the post in the fireplace so we cut a mirror to preview if in fact they wanted it covered at all. If they would of wanted it covered we would of made piece of super 8 stainless steel (highly polished) to cover the post. The mirror was only a temporary visual. DON'T USE REGULAR GLASS NEAR ANY FIRE! So if you are not sure, preview it. The glass we used was a Bronze base glass with Gold base glass and Clear Diamonds.
The fire pit below was purchased locally and then we converted it to burn propane without soot! The colors used were:
Starfire Base Glass,
Here is what is looked like when he started. These manufactures have no imagination!
This only cost about $100.00, complete!
The fire pit below is from Frank Hammond. He created a beach environment in his back yard. He purchased a wood burning fire pit and we converted it to a gas burning pit. We also supplied a quick disconnect gas line to eliminate plumbing underground. he used a Bronze base glass over a bed of crushed lava and topped it with Gold base glass.
The wine barrel below was build by one of our newer dealers in Texas. Matt's Welding. Contact us for information about Matt's wonderful work. We are going to be much more of Matt's work and look around his showroom in the pictures below. Many more projects to come.
There was a steel bowl installed using our propane system to burn our glass. They used Bronze Base Glass in the fire pit.
The fireplace pictures below belong to John Krakowski. This is a complete make over/ transformation of his fireplace. The colors that were used are:
Bronze base glass,
Bronze Reflective base glass,
Yellow Amber Topper,
Dark Red Orange Topper,
This is a very nice self installation: A picture is worth a thousand words!
The next fire table was built by Brian Johnson of Omaha Nebraska, very nice! We supplied the components and Brian did the hard part, the table.
We don't have the construction pictures but we do have the table finished. Add
Bronze Base glass and to pit with 1 lb of Ice, you are done.
The blue is actually food coloring.
On this page we will be posting some real cool fire flame pictures. You're more than welcome to send yours.
This fireplace has:
But you can't see that now. We will be posting daytime pictures so you can see the actual glass. We will be posting the yellow flames as well. We will tell you how to do this in the near future, really!
Comments and testimonial by the customer:
Here are the other shots you requested. I tried many angles, lights, etc., yet could not get an accurate picture of the natural light setting. The silicone carbide is so reflective that it goes to light grey in all of the shots, and the smoke glass looks pale green/blue where in reality it looks almost black.
Another description that may be even more appropriate of the daytime look is that of a neatly piled burned out fire, except that all of the “ash” is reflective and sparkly.
Can not explain why in some of the shots the flame appears greenish. The blue colored flames are not exactly right either. The real color is closer to ultraviolet than anything else.
Several of the shots, including 01, 29, and 50, have been taken from the same location. You can tell the ones taken at full open valve by the increased amount of color in the shots.
Additional photos in separate mailings
I am very happy with my “new” gas fireplace. I thought I would share with you the enclosed photos taken with an ordinary digital camera with no ambient light except the fire itself. The camera was placed in various locations around the fire on the hearth proper. Unfortunately the stills cannot depict the fire action. What is amazing about the fire is the low spread out blue flame pattern instead of the conventional tall yellow flames in the middle.
The fireplace is open on three sides 30”x40”, The pit was filled with coarse bagged lava rock form Home Depot approximately 1” deep to the bottom of the U shaped burner gas pipe with the holes pointing down. It was then topped with Moderustic fine lava rock to fill in the voids on the top leaving the bottom of the burner only slightly submerged below the layer of the finer lava rock from Moderustic..
The next layer was black sand followed by S----- C-----. The sand was mounded in the center over the burners. A sprinkling of grey glass over the SC and a topper of Bronze ½” glass was sprinkled over the smaller sized matrix to finish. The final product is very dark and reflective with tiny reflections off of the s----- c------ and larger reflections off of the gradated glass during the day and in ambient light. It looks a little like a lava field that you might run across in the Mojave Desert near Barstow. Not at all showy, yet very subtle to the view in daylight.
The coarse lava rock on the bottom layer, with the finer layer on top to keep the gas in longer, acts as manifold carrying gas to all portion of the firebox floor covered with that material. I stopped the coarse rock short of the metal posts in a semi circular shape in plan and back filled with sand so that the flame would not reach the posts. The visual result around the posts is that the gas reaching the end of the coarse material immediately goes upward creating a flowing arc of fire around the posts. This is seen as a blur in the photos.
The underlying coarse rock distributes the gas pretty evenly across the firebox floor creating a even matrix of small flames on the surface as it works its way up through the media. The extreme perimeter appears more active. There are more constant more steady flames from the mound. Because there is less gas at the perimeter, the gas there burns in horizontal spurts and appears like lightning bolts licking the edges of the firebox.
There are small vortexes of fire that form and sometimes work there way around the base of the mound on the center but usually preferring a particular area to hang out.
The overall effect is one of a dispersed flame. As if the entire bed of the fireplace is afire with a low blue flame. With all the lights out in the room it is quite magical. Not at all anything like a conventional yellow flame in the center. Due to the dispersion of the flame across the large firebox area, there is a lot of heat generated and dispersed into the room instead of up the flue. This is not a design for summer time nights.
Everyone who witnesses this flame is impressed with the “light show” quality of the burn.
In the future I plan to change out the media and experiment with different ways to direct the gas and resultant flame to achieve different effects.
Next time I am thinking of laying a pattern of coarse rock and infilling between the “arms” of coarse rock with sand so that the gas will follow the “arms” and come up in more predictable places, perhaps creating little vortexes or pyres at the ends of the “arms”.
The fireplace below is in Rancho Mirage just east of Palm Springs California. This is a direct vent fireplace and we used a Bronze Base Glass with Bronze Reflective Base Glass on top. We use the original burner as it would do just fine. We are also cladding the bras with brushed stainless steel and we will post the pictures as soon as we get them. We did two identical fireplaces in this home. One in the master and the other in the family room. You can tell by the back ground.
The next several pictures are of Gisella Hunter in Palm Springs. She had us install a
Blue Green Base Glass, painted the interior a Antique Ruby Red, then she topped it with:
Then if that was not enough, she had us build two VortexED Fires to set next to the fireplace.
Click HERE or on the picture below to see all of the pictures of the Corten Steel Fire Pit!
3/16” Bronze “CLICK HERE TO SEE THIS PRODUCT IN THE E STORE!”